Kenwood NX-5300



• Multi-Digital operation in P25 (Phases 1 & 2) and NXDN™ protocols
• Mixed Digital & FM Analog Operation allows intelligent migration in mixed sites and easy migration with digital radios in other sites
• Large, Color 1.74" (240 x 180 pixels) Transflective TFT Display for better interface even in direct sunlight and with use of polarized sunglasses.
• Easy to follow GUI for at-a-glance operational status checking and Multi-line Text to convey more information
• 4-way Directional-pad (D-pad) and 2-Position Lever Switch for intuitive control and operation
• Built-In GPS Receiver/Antenna for effective fleet management
• Bluetooth® Module built-in for hands-free operation
• Renowned KENWOOD Audio Quality can be achieved with Active Noise Cancelling that utilizes built-in DSP with two microphones for suppression of ambient noise
• Built-in 56-bit DES Encryption
• Optional 256-bit AES Encryption
• Built-in Motion Sensor for life-critical man down detection
• microSD/microSDHC Memory Card Slot for increased memory capacity for “Voice & Data”
• IP67/68 and MIL-STD-810 C/D/E/F/G


• 6 W (136-174 MHz) Models
• 5 W (380-470, 450-520 MHz) Models
• 3 W (700/800 MHz) Models
• Full Key Models (w/ numeric keypad) and Standard Key Models (w/o numeric keypad)
• Maximum of 4,000 CH/Radio capacity, 512 CH/Zone, 128 Zones
• 1 W Loud Speaker Audio


• P25 Phase 1 Conventional/Trunked Operation
• P25 Phase 2 Trunked Operation
• AMBE+2™ Enhanced Vocoder
• Talk Group ID Lists
• Individual ID Lists
• Caller ID Display
• Remote Monitor/Remote Check
• Radio Inhibit
• Encryption Key Zeroize & Retention
• P25 GPS Location
• Over-the-Air Programming*1


• NXDN™ Conventional Operation
• NXDN™ Type-C Trunked Operation
• AMBE+2™ Enhanced Vocoder
• 6.25 & 12.5 kHz Channels
• Over-the-Air Alias
• Over-the-Air Programming*1
• Paging Call
• Emergency Call
• All Group Call
• Status Messaging*2
• Remote Stun/Kill*2
• Remote Check*2
• Short & Long Data Messages*2
• GPS Location
• NXDN™ Digital Scrambler Included


• Conventional & LTR Zones
• NPSPAC (USA only) Channels (±4.0 Modulation)
• FleetSync®/II: PTT ID ANI / Caller ID Display, Selective / Group Call, Emergency Status / Text Messages
• MDC-1200: PTT ID ANI / Caller ID Display, Emergency, Radio Check / Inhibit
• QT / DQT & Two-Tone
• Built-in Voice Inversion Scrambler


• System consists of the optional high-capacity Li-Ion Battery Series (KNB-L1/L2/L3), Rapid Charger (KSC-Y32), and Battery Reader (KAS-12) software
• Up to 30 Rapid Chargers can be chain-connected to a PC installed with the KAS-12
• Battery conditions are displayed in color illuminated indicators on the charger, which are also displayed on a connected PC with the same color scheme
• Up to 1,000 batteries can be managed at a time (requires an additional option)

*1 Requires KENWOOD OTAP Management software.
*2 Requires NX subscriber unit PC serial interface compatible software application (e.g. KENWOOD AVL & Dispatch Messaging software) or hardware (e.g. console).